Max NF665/15 User Manual

NF665/1515 GA. FINISH NAILER15. CLOUEUR DE FINITION A ANGLE DE 15 GaCLAVADORA DE ACABADO ANGULAR DE CALIBRE 15OPERATING AND MAINTENANCE MANUALMANUEL D

10DRIVING FASTENERSNOTE :This tool is shipped with SEQUENTIAL TRIP selected.SEQUENTIAL TRIPThe Sequential Trip requires the operator hold the tool aga

11ALWAYS-disconnect air supply before adjusting adjustment dial.1 If an adjustment is required, disconnect air supply. 2 Refer to the figure for direc

126. MAINTENANCE1 ABOUT PRODUCTION YEARThis product bears production number at the lower part of the grip of the main body. The two digits of the numb

• The content of this manual might be changed without notice for improvement.• Le contenu de ce manuel est sujet a modification sans preavis a des fin

2INDEX INDEX ÍNDICEENGLISH Page 3 to 12FRANÇAIS Page 13 to 22ESPAÑOL Page 23 to 32DEFINITIONS OF SIGNAL WORDSWARNING: Indicates a potentially hazard

3INDEX1. GENERAL SAFETY WARNINGS ...32. SAFETY WARNING...

43. KEEP HANDS AND BODY AWAY FROM THE DIS-CHARGE OUTLETWhen loading and using the tool, never place a hand or any part of body in fastener discharge a

58. DO NOT TOUCH THE TRIGGER UNLESS YOU INTEND TO DRIVE A FASTENERWhenever the air supply is connected to the tool, never touch the trigger unless you

623. WHEN DISPOSING THE MACHINE OR ITS PARTS, FOL-LOW THE RELEVANT NATIONAL RULESOBSERVE THE FOLLOWING GENERAL CAU-TION IN ADDITION TO THE OTHER WARNI

73. SPECIFICATIONS AND TECHNI-CAL DATA1. NAME OF PARTS2. TOOL SPECIFICATIONS∗ The machine has been compactly designed in order to im-prove operating w

84. AIR SUPPLY AND CONNECTIONSFITTINGS: Install a male plug on the tool which is free flowing and which will release air pressure from the tool when d

9NAIL LOADING1 Insert the finish nails into the magazine.2 Pull back the pusher.3 Release and return the pusher.TEST OPERATION1 Adjust the air pressur