Max SN883RH User Manual download pdf (Page 12)

Remove the Switching Lever to the direction of the arrow.

NOTE:

When switching CONTACT ACTUATION with ANTI-DOUBLE FIRE MECHANISM to SINGLE

ACTUATION, equip the Switching Lever with the Spring Pin to the Trigger by reverse procedure.

Switching Lever

PROCEDURE

Hold the Trigger.

Depress the Contact Arm.

CONTACT TRIP MODEL with ANTI-DOUBLE FIRE MECHANISM

The anti-double fire mechanism (US patent 5597106, UK patent 2286790) is installed on this tool.

The common operating procedure on “Contact Trip” tools is for the operator to contact the work to

actuate the trip mechanism while keeping the trigger pulled, thus driving a fastener each time the work is

contacted. This will allow rapid fastener placement on many jobs, such as sheathing, decking and pallet

assembly. All pneumatic tools are subject to recoil when driving fasteners. The tool may bounce,

releasing the trip, and if unintentionally allowed to re-contact the work surface with the trigger still

actuated (finger still holding trigger pulled) an unwanted second fastener will be driven.

CONTACT FIRE OPERATION

For contact fire operation, hold the Trigger and depress the Contact Arm against the work surface.

PROCEDURE

Depress the Contact Arm.

Pull the Trigger.

SINGLE FIRE OPERATION (ANTI-DOUBLE FIRE MECHANISM)

For single fire operation, depress the Contact Arm against the work surface and pull the Trigger. Tool

cannot fire a second nail until the Trigger is released and tool can cycle.

Spring Pin

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

Max SN883RH User Manual Page 12