Max NF255F/18 Use and Care Manual download pdf (Page 8)

TEST OPERATION

1 Adjust the air pressure at 70p.s.i. (5 bar) and connect the air

supply.

2 Without touching the trigger, depress the contact arm

against the work-piece.

Pull the trigger (The tool must fire the fastener.)

3 With the tool off the work-piece, pull the trigger.

Then depress the connect arm against the work-piece. (The

tool must fire the fastener.)

4 Adjust the air pressure as much as the lowest possible ac-

cording the length of fastener and the hardness of work

piece.

AIR HOSE CONNECTION

Connect the air chuck to the air plug.

When connecting the air chuck, do not point the nail dis-

charge outlet at any part of your body or at another person,

and do not touch the trigger.

DRIVING FASTENERS

NOTE :

This tool is shipped with SEQUENTIAL TRIP selected.

SEQUENTIAL TRIP

The Sequential Trip requires the operator hold the tool against

the work before pulling the trigger.

This makes accurate fastener placement easier, for instance on

framing, toe nailing and crating applications.

The allows exact fastener location without the possibility of driving

a second fastener on recall, as described under "Contact Trip".

The Sequential Trip Tool has a positive safely advantage be-

cause it will not accidentally drive a fastener if the tool is contact-

ed against the work or anything else-while the operator is holding

the trigger pulled.

Switching SEQUENTIAL TRIP to CONTACT TRIP

ALWAYS-disconnect air supply before switching the trigger-

ing method.

1 Press the button on the trigger.

2 Turn the switching lever in the direction of the arrow.

3 Set the switching lever as above picture.

WARNING

Button

Switching lever

NF235-255F-USA.book 8 ページ２０１０年７月１２日　月曜日　午後５時２３分

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

No comments

Max NF255F/18 Use and Care Manual Page 8